itshrka

The conventional remote indicator (FX251D) is  a Fire Alarm System designed to provide discreet remote indication, whilst providing the ability to monitor a detector. The FX251D is compatible with the Eaton range of conventional fire systems. The remote indicator is ideal for applications such as void spaces or outside locked or inaccessible rooms to provide indication of the activation of an automatic detector. The device is supplied complete with back box and is surface mounted. Features and benefits • High visibility LED • Fits on to a standard single gang back box • Aesthetically pleasing • Quick and simple to install • Wide viewing angle for increased LED visibility • Discreet design for incorporation into any decor • Easy to maintain/service Installation 1. Mounting plate fixes to single gang back box or can be direct fixed to wall or ceiling. 2. Cable entry is normally from rear but breakouts are provided in side of base plate. 3. Cables connect to [...]

MDP201 it's a Fire Alarm System, Its Duct width range is 300mm to 1500mm, Duct air speed range 1m/s to 20m/s and Temperature range -20°C or +60°C The duct mounting probe unit is designed for use with the Cooper, Menvier and JSB range of analogue and conventional optical smoke sensors / detectors. The presence of smoke in a ventilation duct is detected by sampling the airflow through the duct via two sampling tubes. A detector and base are mounted within the sampling chamber, which is located on the external skin of the duct, with sample and exhaust probes passing into the duct in an area of low turbulence. The unit requires an analogue optical sensor or conventional optical detector and corresponding base and is supplied with full fixing instructions. Selecting Location To avoid excessive turbulence, the duct probe should be placed in a straight section of duct at a distance from any bends of least three duct widths. If the [...]

MAB50R/MAB100R it's a fire alarm system, Two versions of the intelligent addressable loop powered reflective beam detectors are available in this range, the (MAB50R) with a range of up to 50 metres and the (MAB100R) with a range of 50 to 100 meters. Both the (MAB50R) and the (MAB100R) are compatible with the Cooper range of intelligent addressable fire systems. These intelligent addressable loop powered reflective beam detectors are extremely simple to install, they require no separate power supply, operate on a reflective principle and have a simple set up mode to enable easy and quick alignment during installation. These units are designed to replace individual point detectors in large open areas such as warehouses. Fire and fault conditions are signalled to the control panel using standard loop wiring so no additional interconnection required. Features • Loop powered • Soft addressed • Integral short circuit Isolator • Single address • Reflective beam detection • Two ranges available - up to [...]

TL60-RE it's a Sound System, It can be easily flush-mounted using the Paso AC9 box or wall-mounted using the AC93 adapter its range is EUROPA Series attenuators Section : Public Address Category : Attenuators & Selectors Range : EUROPA Series attenuators Code : TL60-RE Description 60W Attenuator The TL60-RE attenuator is equipped with a by-pass relay capable of excluding attenuation in the presence of alarm and/or emergency signals having priority. It can be easily flush-mounted using the Paso AC9 box or wall-mounted using the AC93 adapter. Follow Us on Linkedin Contact Us

TL30 RE FBT it's a Sound System equipped with a by-pass relay capable of excluding attenuation in the presence of alarm and/or emergency signals having priority Section : Public Address Category : Attenuators & Selectors Range : EUROPA Series attenuators Code : TL30-RE Description 30W Attenuator The TL30-RE attenuator is equipped with a by-pass relay capable of excluding attenuation in the presence of alarm and/or emergency signals having priority. It can be easily flush-mounted using the Paso AC9 box or wall-mounted using the AC93 adapter. Follow Us on Linkedin Contact Us

TL10 RE FBT it's a Sound System, It can be easily flush-mounted using the Paso AC9 box or wall-mounted using the AC93 adapter, It's range is EUROPA Series attenuators Section : Public Address Category : Attenuators & Selectors Range : EUROPA Series attenuators Code : TL10-RE Description 10W Attenuator The TL10-RE attenuator is equipped with a by-pass relay capable of excluding attenuation in the presence of alarm and/or emergency signals having priority. It can be easily flush-mounted using the Paso AC9 box or wall-mounted using the AC93 adapter. Follow Us on Linkedin Contact Us