![\"MAB50R\/MAB100R](\"https:\/\/www.kyrcompany.com\/ar\/wp-content\/uploads\/sites\/3\/2024\/02\/MAB50R_R.jpg\")
<\/p>\nMAB50R\/MAB100R \u0646\u0638\u0627\u0645 \u0625\u0646\u0630\u0627\u0631 \u062d\u0631\u0627\u0626\u0642 \u0645\u0646 \u0625\u064a\u062a\u0648\u0646 \u064a\u0634\u0645\u0644 \u0643\u0648\u0627\u0634\u0641 \u062f\u062e\u0627\u0646 \u0648 \u0643\u0627\u0634\u0641 \u062d\u0631\u0627\u0631\u0629 \u0648 \u0644\u0647\u0628 \u0648\u0645\u0627\u0646\u0648\u0644<\/p>\n
MAB50R\/MAB100R it’s a fire alarm system, Two versions of the intelligent addressable loop powered reflective beam detectors are available in this range, the (MAB50R) with a range of up to 50 metres and the (MAB100R) with a range of 50 to 100 meters.<\/p>\n
Both the (MAB50R) and the (MAB100R) are compatible with the Cooper range of intelligent addressable fire systems.<\/p>\n
These intelligent addressable loop powered reflective beam detectors are extremely simple to install, they require no separate power supply, operate on a reflective principle and have a simple set up mode to enable easy and quick alignment during installation.<\/p>\n
These units are designed to replace individual point detectors in large open areas such as warehouses.<\/p>\n
Fire and fault conditions are signalled to the control panel using standard loop wiring so no additional interconnection required.<\/p>\n
<\/p>\n
\u2022 Loop powered
\n\u2022 Soft addressed
\n\u2022 Integral short circuit Isolator
\n\u2022 Single address
\n\u2022 Reflective beam detection
\n\u2022 Two ranges available
\n– up to 50m
\n– up to 100m<\/p>\n
\u2022 Quick and simple to setup
\n\u2022 Saves on both time and installation costs
\n\u2022 No power supply required
\n\u2022 Single device to install instead of numerous point detectors
\n\u2022 Single point of maintenance
\n\u2022 Wall mounted for ease of maintenance, especially in warehouses with racking<\/p>\n
1.Must be fixed to solid structure.
\n2. Recommended mounting height is 0.3 to 0.6 metres below the ceiling.
\n3. Cables can be terminated into separate termination box (not supplied) or use purpose designed mounting bracket (MRBFP) ordered separately.
\n4. Mounting bracket has facilities for glanding of incoming cables plus simple fixing of beam detector.
\n5. Test filter is supplied with detector to simulate required smoke obscuration level and confirm correct operation.<\/p>\n
1. Beam detectors status LEDs
\n\u2022 Red LED constantly illuminated indicates fire condition.
\n\u2022 Flashing amber LED indicates fault condition<\/p>\n
1. Beam detectors have 3 modes:
\n\u2022 Prism targeting mode – designed to provide simple initial alignment of beam and reflector assembly.
\n\u2022 Alignment mode – Enables accurate fine tuning of beam alignment without the need for additional calibration equipment or a second operator.
\n\u2022 Normal running mode<\/p>\n